Tratamiento térmico de un acero de medio carbono modificado con una adición del 3% en peso de cromo

En el presente trabajo se lleva a cabo un estudio de tratamientos térmicos y caracterización a un acero de medio carbono modificado con la adición de 3% en peso de Cromo. Para la caracterización del acero se inició con la composición química por medio del ensayo de espectroscopia de emisión atómica,...

Full description

Autores:
Rodriguez Redondo, Juan Sebastian
Zabaleta Niño, Jefferson Daniel
Tipo de recurso:
http://purl.org/coar/version/c_b1a7d7d4d402bcce
Fecha de publicación:
2016
Institución:
Universidad Industrial de Santander
Repositorio:
Repositorio UIS
Idioma:
spa
OAI Identifier:
oai:noesis.uis.edu.co:20.500.14071/34929
Acceso en línea:
https://noesis.uis.edu.co/handle/20.500.14071/34929
https://noesis.uis.edu.co
Palabra clave:
Aceros De La Serie 4Xxx
Acero Aisi-Sae 4140 Y 4340
Templabilidad
Resistencia A La Tracción
Microestructura
Tratamientos Térmicos.
In this paper is carried out a study of heat treatments and characterization to a modified medium carbon Steel with an addition of 3wt% of Chrome. For the characterization of steel began with the chemical composition through the atomic emission spectroscopy test
where it was found that is an Steel that is accommodates in 4XXX series of AISI-SAE. Also
it was performed a X-ray diffraction test (XRD) to know the compounds formed by the 3wt% addition of chrome. Later it was performed the metallography (inclusions
phases present and grain size) and hardness and microhardness test of the supplied modified steel to observe the casting microstructure and know the influence this had on the mechanical properties of the material. Then it was performed hardenability and tensile strength tests. All tests were made following ASTM respective. Taking into account the alloying elements presents in the modified steel
CCT y TTT diagrams of the similar Steel in their chemical composition and the size of the piece
it was performed the design and application of the heat treatments of annealing
temper and tempering. After this
it was performed a metallographic and hardness analysis for each of heat treatment pieces. Finally
it was performed a comparison between the modified Steel in studied and the AISI-SAE 4140 Steel of the heat treatment performed.
Rights
License
Attribution-NonCommercial 4.0 International (CC BY-NC 4.0)