Adsorption capacity of the biochar obtained from Pinus patula wood micro-gasification for the treatment of polluted water containing malachite green dye

In this work, the adsorption capacity of the biochar obtained from Pinus patula biomass micro-gasification was studied using malachite green (MG) as the probe pollutant. For this purpose, the biomass type (wood pellets and chips) was selected to produce two kinds of biochar (BC). Afterwards, the eff...

Full description

Autores:
Rubio Clemente, Ainhoa
Gutiérrez Vanegas, Jonatan
Pérez Bayer, Juan Fernando
Chica Arrieta, Edwin Lenin
Melo Moreno, Ana María
Henao Toro, Hillary
Tipo de recurso:
Article of investigation
Fecha de publicación:
2021
Institución:
Tecnológico de Antioquia
Repositorio:
Repositorio Tdea
Idioma:
eng
OAI Identifier:
oai:dspace.tdea.edu.co:tdea/2711
Acceso en línea:
https://dspace.tdea.edu.co/handle/tdea/2711
Palabra clave:
Circular economy
Economía circular
Water Pollution
Contaminación del Agua
Poluição da Água
Response surface methodology
Biochar
Dye adsorption
Biomass micro-gasification
Rights
openAccess
License
https://creativecommons.org/licenses/by-nc-nd/4.0/
Description
Summary:In this work, the adsorption capacity of the biochar obtained from Pinus patula biomass micro-gasification was studied using malachite green (MG) as the probe pollutant. For this purpose, the biomass type (wood pellets and chips) was selected to produce two kinds of biochar (BC). Afterwards, the effects of the adsor- bent dose (6, 9 and 12 g/L), the solution pH (4, 7 and 10) and the BC particle size distribution (150–300, 300–450 and 450–600 lm) for the maximization of the MG retention by the selected BC were evaluated using a faced-centered central composite design, as response surface methodology. The results indicated that the BC derived from wood chips (BWC) exhibited a higher MG dye adsorption capacity than the BC obtained from the wood pellets (BWP) gasification under the same operating conditions after having reached the equilibrium. A second-order regression model was built for describing the MG adsorption behaviour by BWC under the considered experimental domain. The model, which was validated, resulted to be statistically significant and suitable to represent the MG adsorption by the studied BC with a p- value of 0.00 and a correlation coefficient (R2) of 95.59%. Additionally, a three-dimensional response sur- face graph and a contour plot were utilized to analyze the interaction effects between the factors influ- encing the adsorption system and to discern the optimal operating conditions for the use of BWC. The maximal MG dye retention (99.70%) was found to be at an adsorbent dose, pH solution and a particle size distribution of 9.80 g/L, 10 and from 150 to 300 lm, respectively. Therefore, the BWC tested can be uti- lized for the treatment of water polluted with dyes, contributing to the establishment of a circular economy.