Influence of indenter diameter on dynamic indentation tests of PEGT and PA6 thermoplastics
In this article the results of the impact characterization of PETG and PA6 thermoplastics are presented, they have been characterized statically and dynamically by the indentation test, and mathematical models developed in previous works have also been used to adjust the obtained models. The Indente...
- Autores:
-
Coba Salcedo, Milton Fabian
Acevedo Peñaloza, Carlos Humberto
Prada Botia, Gaudy Carolina
- Tipo de recurso:
- Article of journal
- Fecha de publicación:
- 2018
- Institución:
- Universidad Francisco de Paula Santander
- Repositorio:
- Repositorio Digital UFPS
- Idioma:
- eng
- OAI Identifier:
- oai:repositorio.ufps.edu.co:ufps/6369
- Acceso en línea:
- http://repositorio.ufps.edu.co/handle/ufps/6369
https://doi.org/10.12988/ces.2018.88440
- Palabra clave:
- Impact resistance
Indentation test
PETG
PA6
- Rights
- openAccess
- License
- Atribución-NoComercial-SinDerivadas 4.0 Internacional (CC BY-NC-ND 4.0)
| Summary: | In this article the results of the impact characterization of PETG and PA6 thermoplastics are presented, they have been characterized statically and dynamically by the indentation test, and mathematical models developed in previous works have also been used to adjust the obtained models. The Indenter diameter of the impactor used were studied. The results have shown that the specimen thickness influences the value of some of the measured properties as the thickness increases, as well as that the impactor mass influences the velocity that is printed during the test run. |
|---|