Effects of Line and Pillar Array Microengineered SiO2 Thin Films on the Osteogenic Differentiation of Human Bone Marrow-Derived Mesenchymal Stem Cells

A primary goal in bone tissue engineering is the design of implants that induce controlled, guided, and rapid healing. The events that normally lead to the integration of an implant into bone and determine the performance of the device occur mainly at the tissue-implant interface. Topographical surf...

Full description

Autores:
Carvalho A.
Pelaez Vargas, Alejandro
Hansford D.J.
Fernandes M.H.
Monteiro F.J.
Tipo de recurso:
Article of journal
Fecha de publicación:
2023
Institución:
Universidad Cooperativa de Colombia
Repositorio:
Repositorio UCC
Idioma:
OAI Identifier:
oai:repository.ucc.edu.co:20.500.12494/49575
Acceso en línea:
https://doi.org/10.1021/acs.langmuir.5b03955
https://www.scopus.com/inward/record.uri?eid=2-s2.0-84957546860&doi=10.1021%2facs.langmuir.5b03955&partnerID=40&md5=6a5742d355ca6e72b9638fef3218213f
https://hdl.handle.net/20.500.12494/49575
Palabra clave:
ATOMIC FORCE MICROSCOPY
BASAL CONDITIONS
BIOCHEMICAL STIMULI
BONE
BONE TISSUE ENGINEERING
CELL CULTURE
CELL DIFFERENTIATION
CELLS
CELLS, CULTURED
CYTOLOGY
CHEMISTRY
EXTRACELLULAR MATRICES
HUMAN
HUMAN BONE MARROW DERIVED MESENCHYMAL STEM CELLS
HUMANS
MESENCHYMAL STROMA CELL
MESENCHYMAL STROMAL CELLS
MICROTECHNOLOGY
OSTEOCLAST
OSTEOCLASTS
OSTEOGENIC DIFFERENTIATION
REVERSE TRANSCRIPTASE POLYMERASE CHAIN REACTION
REVERSE TRANSCRIPTION POLYMERASE CHAIN REACTION
SCANNING ELECTRON MICROSCOPY
SILICA THIN FILMS
SILICON DIOXIDE
SOL-GELS
STEM CELLS
SURFACE TREATMENT
THIN FILMS
TISSUE
TISSUE ENGINEERING
TISSUE IMPLANTS
Rights
openAccess
License
http://purl.org/coar/access_right/c_abf2
Description
Summary:A primary goal in bone tissue engineering is the design of implants that induce controlled, guided, and rapid healing. The events that normally lead to the integration of an implant into bone and determine the performance of the device occur mainly at the tissue-implant interface. Topographical surface modification of a biomaterial might be an efficient tool for inducing stem cell osteogenic differentiation and replace the use of biochemical stimuli. The main goal of this work was to develop micropatterned bioactive silica thin films to induce the osteogenic differentiation of human bone marrow-derived mesenchymal stem cells (hMSCs) only through topographical stimuli. Line and pillar micropatterns were developed by a combination of sol-gel/soft lithography and characterized by scanning electron microscopy, atomic force microscopy, and contact angle measurements. hMSCs were cultured onto the microfabricated thin films and flat control for up to 21 days under basal conditions. The micropatterned groups induced levels of osteogenic differentiation and expression of osteoblast-associated markers higher than those of the flat controls. Via comparison of the micropatterns, the pillars caused a stronger response of the osteogenic differentiation of hMSCs with a higher level of expression of osteoblast-associated markers, ALP activity, and extracellular matrix mineralization after the cells had been cultured for 21 days. These findings suggest that specific microtopographic cues can direct hMSCs toward osteogenic differentiation. © 2016 American Chemical Society.